Product introduction
The product is made of water-soluble acrylic resin and water-soluble amino resin, water-based special antirust pigment and additives and deionized water through refined processing, has the advantages of safety, environmental protection, construction of good characteristics, densecoating adhesion, salt fog performance, single component packaging, easy to use.
Use
Mainly used in machinery and equipment, automobile chassis, vehicle frame, radiator, radiator and other metal components of the protective and decorative coating.
Product data
Color specified color
Gloss (60 DEG) / unit value is less than or equal to 70 or the specified luster
The hardness (pencil) = H
The adhesion level is less than or equal to 1
Impact resistance, kg.cm 50
Water resistant 168h film without blistering and shedding phenomenon
Construction description
Coating method
Thinner deionized water or tap water
Tool cleaning tap water
Drying conditions 140 to 160 c * 30min
The dilution ratio is less than 10%
Flash time 15 ~ 25min (ambient temperature of >15 DEG C, relative humidity of < 75%)
Dry film thickness of more than 15 m
Matters needing attention
1, the metal substrate before coating to the surface, removing oil and rust, zinc phosphating treatment, otherwise it is not up to
Expected effect.
2, water-based paint should be stored at 5 to 30 degrees of ventilation and dry place, avoid freezing.
3, water-based paint is diluted with deionized water (or conductivity less than 100 S/cm clean tap water)
In addition to the mixing, due to the water-based paint after adding water viscosity effect is not obvious, so it can not add too much water, the general amount of water can not exceed 10% of the paint, spray viscosity control in the 25 ~ 35S (-4 cup /25).
4, a coating of the dry film thickness can not be too thick, so as to avoid the phenomenon of baking holes.
5, the painting, according to the different environment temperature, wet film need enough time to flash, can enter
Bake in the oven, or 60 ~ 80 DEG C low temperature preheated 10min and then into the oven at 140 degrees Celsius, otherwise there will be holes, bubbles and other undesirable phenomena.
6, is strictly prohibited contact with oily substances, while the ambient temperature is below 5 degrees C or humidity is greater than 75%, can not be constructed.
7, that paint or particles, with 80 ~ 200 mesh filters, water paint over the storage period shall be subject to the
Inspection, no quality problems can be used.
Storage period
Should be stored at 5 to 30 degrees in the dry and ventilated place sealed preservation, storage period of 6 months.
Packing specification 20kg/ barrel
Statement: paint many factors in construction directly affects the coating effect and service life, the information and data are based on our experimental testing and actual use of the experience accumulated for the construction, when we do not understand the situation, we can only guarantee the quality of the paint. The above data are subject to change, subject to the company's latest specifications, without prior notice.
